Skip to content
Water Heater Installation in Exeter, CA
Same-day available Water Heaters

Water heater replacement

Water Heater Installation in Exeter, CA

Cold water at every tap, a puddle by the tank, and a purchase you never planned to make today.

We help Exeter homeowners and landlords choose the right replacement, install it to the current California Plumbing Code, and brace it the way state law requires, usually on the same day you call.

Response
Same day on most standard tank swaps
Pricing
Agreed before we start
Licensed
CSLB #1072777
Rated
4.9 Google

What is it doing right now?

Describe the symptom. You get a real diagnosis and a price range back, not a call-out fee to find out.

No obligation, no upfront fee. We will never sell your details.
In a genuine emergency, calling is faster: (559) 648-6871

Sound familiar?

You are probably here because of one of these.

  • Water pooling under the tank again after you have wiped the floor dry
  • Rust-brown hot water from every faucet while the cold side runs clear
  • White crust and green corrosion around the pipe fittings on the tank top
  • A tank that rocks when you lean on it because the straps are slack or missing
  • Hot water that gives out noticeably sooner than it did a year ago
What is really going on

The problem underneath the symptom

01

The old tank quit before you had a plan

Water heaters never pick a convenient retirement date. One morning there is water spreading from under the tank or the showers simply stay cold, and suddenly you are shopping for an appliance with a wet floor and a household waiting to get ready. That is a bad moment to be upsold and a fair moment to get straight answers.

02

Nobody knows whether the old install was ever legal

Plenty of tanks were set in place years ago with a single loose strap, a relief line that stops in mid-air, or a gas connector that has been bent one too many times. When the heater is replaced, all of that should be brought up to current code rather than reconnected exactly the way it was.

03

You rent it out, rent it, or are about to sell it

In a rental, the tenant discovers the failure but the owner signs off on the work. In a sale, the seller has to certify the heater's earthquake bracing to the buyer in writing. Each situation needs the install done properly and documented clearly, not just a tank that makes hot water.

When the tank gives out on a weekday morning

It usually starts with someone calling out from the shower. Then you find the water: a dark ring creeping across the garage slab, or a closet carpet that squelches underfoot. The tank that quietly did its job for years is finished, and now there is a work day, a family that needs to get ready, and a choice to make about something you have never had to shop for.

Our job at that point is to slow the decision down just enough that you make a good one. Close the cold water valve above the tank so it stops refilling. On a gas heater, turn the control knob to off or pilot. On an electric heater, switch off its breaker. Then call, and we will talk through what you have and what makes sense to put in its place.

If you are not certain the tank is really finished, a repair visit may be the right first step. A leaking relief valve or drain valve can look a lot like a failed tank.

What California law asks of every water heater in Exeter

Many people think of water heater straps as an extra the installer might add. In California they are a legal requirement. Health and Safety Code section 19211 says that all new and replacement water heaters, and all existing residential water heaters, must be braced, anchored or strapped to resist falling or horizontal movement during an earthquake, at minimum to the standard in the California Plumbing Code. The rule applies to standard heaters of 120 gallons or less where a pre-engineered strapping kit is readily available, which is a plain description of an ordinary household tank.

Two things follow from that wording. The duty is not limited to new installs, so an existing heater held by one slack strap falls short today. And a replacement is the obvious time to fix it, because the tank is empty and the wall behind it is easy to reach.

On our installs the straps wrap the tank in its upper and lower thirds and anchor into wall framing, with the lower strap kept clear of the controls. A full tank weighs far too much for straps screwed only into drywall, and a heater that tips in a quake can tear its gas and water connections loose.

The rest of the install answers to the state code as well. The 2025 California Building Standards Code, which includes the California Plumbing Code, took effect statewide on January 1, 2026, and permit applications submitted on or after that date fall under the 2025 edition. Replacing a water heater is not among the narrow repairs the Plumbing Code exempts from permits, so we pull permits where the work requires them and build the install to pass. In practice that means a relief valve whose discharge line runs to an approved termination, a correct gas connector and shutoff, proper venting and combustion air on gas units, a drain pan where the location calls for one, and a check for thermal expansion if your system has a check valve or regulator holding heated water in.

Renting it out, living in it, or selling it

Exeter has a large rental market. Census estimates for 2020 to 2024 put roughly 45 percent of the city’s occupied homes in renter hands. That changes who calls us and who signs off.

  • Owner-occupied. You choose the replacement and approve the written quote. Simple.
  • Rental. The tenant usually notices the failure first, but the owner or property manager approves the work. We take access details and a description from the tenant and send the quote to whoever is authorizing it. Because the bracing law reaches existing heaters too, a rental replacement should leave the new tank strapped to code.
  • Selling. Section 19211 requires the seller to certify to the buyer in writing that the heater is braced as required. If you are listing an Exeter house and are unsure about the old straps, sort it out before escrow raises the question. A pre-sale plumbing inspection can cover the heater along with the rest of the system.

Choosing what goes in its place

A like-for-like swap is often the right call. If a standard tank has served the household well, staying with the same fuel and a similar capacity keeps the job simple and fast. We still check the size against how the house uses water now, because a home that has added people since the last tank went in may need more capacity or a model that recovers faster.

Sometimes a different type is worth a look. An on-demand tankless system frees up floor space and does not run dry mid-shower, though it needs adequate gas supply and its own venting. A heat pump water heater can sharply reduce electric use in a warm garage. We will tell you honestly when a switch is worth it and when it is not, and we will not turn an emergency replacement into a bigger project than you asked for.

Getting a written quote

The installation price depends on fuel type and capacity, whether venting, gas or electrical work has to change, how hard the old tank is to remove, and which code corrections the new install needs. We look first and quote second. The number you approve in writing is the number you pay unless you okay a change.

All Flow Plumbing is an Exeter business owned by Jim Smith, licensed under CSLB #1072777, bonded and insured, with a 4.9 average on Google and an A+ rating from the BBB. Call (559) 648-6871 at any hour, and on a standard tank swap we can usually have hot water running again the same day.

How it goes

From your call to a working water heater installation

  1. 1

    Size and fuel check

    We confirm what the house has now, gas or electric, tank capacity, venting and available space, and ask how many people shower in the morning. That decides whether a like-for-like swap makes sense or a different size or type would serve the house better.

  2. 2

    Quote in hand before anything is removed

    You receive the installation price in writing, including any code corrections the new install needs. Nothing is drained or disconnected until you approve it, and the figure only moves if you sign off on a change.

  3. 3

    Remove, set and connect

    We drain and disconnect the old tank, set the new one level on a proper base, and make new water and gas or electrical connections. The relief valve gets a discharge line run to an approved termination, and gas venting is checked for a proper draft.

  4. 4

    Brace, fire and walk through

    The tank is strapped in its upper and lower thirds into the wall framing, filled, purged of air and brought up to temperature. We check every joint for leaks, test the temperature at a tap, and show you the cold shutoff, the gas valve and the relief valve before we leave.

Local knowledge

Seismic bracing is the law for every tank in Exeter, rented, owned or sold

California Health and Safety Code section 19211 requires all new and replacement water heaters, and all existing residential water heaters, to be braced, anchored or strapped so they resist falling or shifting sideways in an earthquake, at minimum to the California Plumbing Code. It covers standard heaters of 120 gallons or less for which a pre-engineered strapping kit is readily available, which describes the typical household tank. The same section requires anyone selling a property with a water heater to certify compliance to the buyer in writing. That reaches a lot of Exeter households. Census estimates for 2020 to 2024 count about 1,478 of the city's 3,262 occupied homes, roughly 45 percent, as renter-occupied, and the owners of those homes carry the bracing duty whether or not they live in them. A replacement installed to code is the simplest moment to meet it, because the tank is empty and the wall behind it is open to work on.

Exeter, CA Same day on most standard tank swaps CSLB #1072777
Water Heater Installation in Exeter, CA. All Flow Plumbing technician installing a new tank water heater
Water Heater Installation · Exeter, California
FAQ

Questions people actually ask

Straight answers about water heater installation in Exeter, no hedging, no upsell.

What does it cost to install a new water heater in Exeter?

The price comes from the details of your setup. Fuel type and capacity matter, as do any changes to venting, gas piping or wiring, how hard the old tank is to get out, and which code corrections the new install needs, such as proper bracing, a relief discharge line or an expansion tank. We look first, then give you an exact written price that only changes if you approve it.

Can you replace my water heater the same day in Exeter?

For a standard tank swap, usually yes. We are based in Exeter, so in-town calls are close to home base and same-day installs are normal when the replacement is a common size and fuel. Switching to a different type, moving the heater or waiting on a special-order unit takes longer, and we tell you which applies when you call.

I am selling my house in Exeter. What do I have to do about the water heater?

California Health and Safety Code 19211 requires a seller to certify to the buyer, in writing, that the water heater is braced, anchored or strapped as the law requires. If you are not sure the existing straps meet the Plumbing Code, have them checked before you list. We can brace an existing tank properly or tell you exactly what needs correcting.

I rent out a house in Exeter. Who should call you when the water heater fails?

Either the tenant or the owner can call. We take access details and a description of the problem from whoever is at the house, and the written quote goes to the person authorizing the work, usually the owner or property manager. Because the bracing law covers existing heaters too, a replacement in a rental should leave the new tank strapped to code.

Do I need a permit to replace a water heater?

Replacing a water heater is not one of the narrow repairs the California Plumbing Code exempts from permits, and permit applications submitted since January 1, 2026 fall under the 2025 edition of that code. We pull permits where the work requires them and build every install to pass inspection, so the paperwork does not become your problem later.

Will my new water heater need an expansion tank?

It depends on your system. When a check valve or pressure regulator stops heated water from expanding back toward the street, the extra volume has nowhere to go, and the relief valve may drip or pressure may spike each heating cycle. An expansion tank gives that water somewhere to go. We check for this during the install and tell you plainly whether your house needs one.

Should I switch to tankless or a heat pump while I am replacing the tank?

Sometimes. A tankless unit saves floor space and never runs out mid-shower but may need a larger gas line and new venting. A heat pump model can use far less electricity in a warm garage but needs wiring and room. If you need hot water today, a like-for-like swap is often the sensible move, and we can plan an upgrade later.

Still reading?

It will not fix itself, and it will not get cheaper.

Ten minutes on the phone usually tells you whether this is a small repair or a real project. That call costs nothing, and you get a real answer either way.

Reviewed by Jim Smith, Licensed Plumbing Contractor · Updated October 2026

Get a straight answer, fast

Tell us what is happening. We reply with a real diagnosis and a price range, usually within the hour.

No obligation, no upfront fee. We will never sell your details.
In a genuine emergency, calling is faster: (559) 648-6871

(559) 648-6871 Book