Before you blame the water
When a pipe starts leaking, plenty of people assume something in the water is eating it. In Exeter, the City’s own testing does not support that.
In September 2023 the City sampled tap water at 30 homes for lead and copper, the two metals its report traces mainly to household plumbing rather than to the wells. According to the 2025 Consumer Confidence Report, none of those 30 homes went over the lead action level, and none went over the copper one. At the 90th percentile, copper measured 0.25 parts per million, against an action level of 1.3.
The same report is plain about where those metals originate when they do show up, which is pipes and fittings corroding inside homes. It adds that the City cannot choose what anyone’s household plumbing is made of. Put simply, the supply side is tested and regulated, and what happens inside your walls depends on your house: the pipe it was built with, how that pipe was installed and what has happened to it since.
That is how we approach every pipe repair in Exeter. We do not assume the cause. We find it.
What really breaks pipe in a 1970 to 1999 house
Census estimates show the 1970s, 80s and 90s produced nearly half of Exeter’s housing, so most of the pipe we repair in town is somewhere between 25 and 55 years old. Age alone does not break a pipe. These things do:
- Joints, not runs. A soldered or glued joint that was rushed during construction is often the first point to let go, sometimes many years later.
- Rubbing. Pipe that touches a stud, a strap or another pipe shifts slightly every time water starts and stops, and wears thin at the contact point.
- Water hammer and high pressure. A bang in the walls when a valve shuts is a pressure spike. Repeated thousands of times, it loosens fittings. Steady high pressure does similar damage more quietly.
- Mixed metals. Where copper meets steel without the proper fitting, the joint can corrode from the inside.
- Physical damage. A nail through drywall, a shelf screw, a shovel in the yard, or a hard freeze on an exposed outdoor or garage line.
- Flexible connectors. The braided or rubber lines under sinks and toilets age faster than the pipe behind them.
Homes built before 1970 may still have galvanized steel supply pipe, which rusts from the inside and narrows over time. Whether yours does is something we check on site, never something we assume from the year the house was built.
Repair, or new work that needs a permit
California’s Plumbing Code draws a line that shapes how a pipe repair is handled. Under Section 104.2, only a short list of work skips the permit. Sealing a leak on a drain, waste or vent line qualifies. So does clearing a blockage. So does fixing a leaking pipe, valve or fixture, provided nothing gets swapped out or moved.
Once a damaged length of pipe comes out and new pipe goes in, the code calls that new work, and Section 104.1 puts it under a permit. Permit applications submitted since January 1, 2026 fall under the 2025 edition of the California Plumbing Code.
That distinction is why we explain the scope before we start. Tightening or resealing a fitting may count as a repair. Replacing a few feet of corroded pipe usually does not. Where the job needs a permit, we take care of it, and you will know beforehand whether yours is permitted work.
Matching the fix to the pipe in front of us
Every material has its own correct repair, and the wrong one is how a fixed leak comes back.
- Copper is cut back to clean, sound pipe and rejoined with soldered or press fittings.
- PEX is repaired with crimp or expansion fittings that match the tubing system.
- CPVC is cut square and solvent-welded, and handled gently, since older CPVC can turn brittle.
- Galvanized steel is usually transitioned to a modern material with a proper dielectric fitting rather than patched with more steel.
- Drain lines in ABS or cast iron are repaired with matching material or an approved transition coupling.
Before anything is closed up, we put the line back under pressure, watch for weeping, and look over whatever else is visible while the wall or ceiling is open.
When patching stops being the right answer
One leak on otherwise sound pipe is a repair. A second leak a few months later on the same type of pipe is information. If we find pipe that is thin, scaled inside or corroded at more than one joint, we will point it out and show you, and a repipe for your Exeter home becomes a fair conversation. If the leak arrived with banging pipes, it is worth having us check the water pressure and regulator before the next joint goes. And if you are not sure where the water is coming from at all, locating the leak first saves opening the wrong wall.
Stopping the drip tonight
Close the shutoff under the fixture, or the main house valve if the leak is on a supply line. Then call (559) 648-6871. Our crew works out of Exeter and picks up the phone at any hour, and an active leak gets handled the same day. If a genuine night callout carries an after-hours rate, you hear it on the phone before we head out, and the repair price is in writing before work begins. We hold California contractor license CSLB #1072777 and carry bonding and insurance.